DJI M350
Integration instructions for DJI M350
Last updated
Integration instructions for DJI M350
Last updated
1
Locate the four screw holes for installing the payload mount
2
Using the M3x10 screws, install the payload mount. Payload insertion point should be aligned with the front of the aircraft.
3
Place the power delivery module on top of the aircraft.
4
Locate the four screw holes for the power delivery module.
5
Using the M3x6 screws, install the power delivery module. USB-C port should be facing the rear of the aircraft, power cable should come off the right side of the aircraft when looking from the back.
6
Attach the power delivery cable from the module to the aircraft. Follow the attached DJI documentation. The B side of the power module side should face up.
7
The B side of the aircraft side should face out.
8
Install the antenna mounts. Locate and line up the notches on the antenna mount and C-bracket when installing.
9
Antenna mount should sit flush against the end of the rotor arm.
10
Antenna A1 should be installed on the rear left of the aircraft.
11
Antenna A2 should be installed on the rear right of the aircraft.
12
Ensure the antenna mounts are level with the ground.
13
Loosely zip tie the antenna cables to the back of the payload mount.
14
Make sure the rotor arms can properly fold.
15
Fully secure the zip ties.
16
Using the included gaff tape, secure the GNSS antenna cable on both sides of the aircraft so the propellers cannot reach them. Also ensure the rotor arm locking system is able to extend far enough that the rotor arms can still be closed.
17
Zip tie the gaff tape/cable to the rotor arm for further security.