Integration instructions for Inspired Flight IF1200A
1
Using existing screw holes, remove four screws and washers at the front left (A1) and back right (A2) corners of the IF1200.
2
Place the antenna mast base plate on the aircraft over the screw holes, aligning the triangular cutout with the hull's interior lip.
3
Place washer over screw hole on base plate, and install M4x14mm screws.
4
Repeat process for second antenna mast base plate.
5
Route coax cables through vibration damper, zip tie cable to damper to keep safe from spinning propellers.
6
When in the field, install antenna mast A1 (front left) with Trimble AV18 antenna.
GRYFN Gobi will use both 8" antenna masts, installing the two included Maxtena M7HCT antennas.
Last updated 6 months ago
