Configuration

In order for the PWM output of the M600 flight controller to be user-controlled and compatible with the GRYFN Mojave payload, the M600 flight controller must be re-configured to map an RC switch to the F8 output connected in the Installation section of this document.

Channel Mapping Instructions

1. Power on the M600

2. Connect the M600 to a PC and run DJI Assistant 2

3. Enter the M600 configuration

4. Click "Tool" on the left of the interface and enter the “Function Channel” page

5. Couple the the F8 function output to the S6 switch and configure it as shown below.

Correct F8 PWM configuration