GRYFN Hardware
GRYFN Resources
GRYFN Accessories
GRYFN Accessories
  • Welcome
  • GRYFN Airborne Reflectance Panels
    • Standard Panel Set
    • High Altitude Panel Set
    • Spectral RGB Panel
    • Cleaning Panels
  • GRYFN Mojave M600 Integration Kit
    • Installation
    • Configuration
    • Mounting the Payload
  • GRYFN Alta X Modifications
    • DroneAmplified Landing Gear
    • GNSS Antenna Mast
Powered by GitBook
On this page
  1. GRYFN Alta X Modifications

GNSS Antenna Mast

PreviousDroneAmplified Landing Gear

Last updated 10 months ago

Installing Antenna Mast

GRYFN Payloads rely on high-quality GNSS inertial navigation data. The Freefly Alta X must have an antenna mast, antenna, and cable installed to connect to the GNSS receiver on-board the payloads.

To begin installation of the GNSS antenna components:

  1. Install the antenna adapter onto the antenna mast using the two screw holes at the top of the antenna mast

  2. Locate the free mounting point at the back right of the aircraft, just beside the battery terminals

  3. Attach the antenna mast to the mounting area using the four included screws

  4. Feed the coaxial cable through the antenna mast adapter

  5. Screw the antenna onto the cable

  6. Feed the coaxial cable through the center of the UAV, so it is accessible under the UAV where the payload will mount

    1. test

  7. To secure the coaxial cable, zip tie it to the antenna mast